Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 51)

Chapter
Access Manager 2000 User Manual 2-1
2
Installing Access Manager
This chapter provides instructions for installing Access Manager. It also
describes the host personal computer and peripheral equipment
requirements for Access Manager operation.
Equipment Installation
Before installing Access Manager, verify that your system meets the
requirements listed below. These basic system requirements have been
tested and are known to be compatible with Access Manager.
These are the minimum system requirements for Access Manager.
Parameter Requirements Recommendations and Notes
Host computer
model AM2000 may be installed on
one of the following:
• IBM PS/2 Model 80
• AT&T 6386/SX WGS
• 100%-compatible 386 PC
Use a color monitor with the
appropriate graphics adapter.
A VGA monitor is recommended.
Operating
system DOS version 5.0 or later on the
host PC. DOS must be fully
and properly installed.
RAM Host: 640K of base memory
Accumaster: 192K
Total: 4 megabytes minimum
To use expanded or extended on-
board memory, see your application
engineer for the specifications on
configuring your system.
Hard disk
memory Use a minimum 80-megabyte
hard disk with fast access (less
than 20 milliseconds). Program and overhead files take 2
megabytes. The rest is for data
storage.
Recommended
software drivers • himem.sys
• smartdrv.exe
These are very strongly
recommended.
Minimum System
Requirements