Caution – Verilink Access Manager 2000 (896-502037-001) Product Manual User Manual
Page 382
D-12
Access Manager 2000 User Manual
CAUTION
Do not install software drivers provided by Digiboard for the PC/16 o
PC/16. Since Access Manager has its own drivers for these boards,
using the Digiboard drivers will prevent Access Manager from
working with the PC/16 or PC/16.
4
COM5
118H
3H
140H
3H
5
COM6
120H
3H
140H
4H
6
COM7
128H
3H
140H
5H
7
COM8
130H
3H
140H
6H
8
COM9
138H
3H
140H
7H
9
COM10
148H
3H
140H
8H
10
COM11
150H
3H
140H
9H
11
COM12
158H
3H
140H
AH
12
COM13
160H
3H
140H
BH
13
COM14
168H
3H
140H
CH
14
COM15
170H
3H
140H
DH
15
COM16
178H
3H
140H
EH
16
(See Note 1)
180H
3H
140H
FH
NOTE 1. Table D-7, “Serial Ports for DigiCHANNEL PC/16 in IBM PC, XT, and AT,” on pageD-11 assumes you
computer is equipped with a built-in serial port at COM1. The DigiBoard ports should not include Comlines that are
built into your PC and cannot be disabled; therefore, this table starts with COM2.
However, if your computer is not equipped with a built-in serial port, number the DigiBoard ports from COM1 through
COM 16.The DigiBoard’s first COM port is always given Port A ddress=100H. All of the Digiboard’s other ports are
addressed according to the tables in this appendix.
NOTE 2. The options shown are the factory default options. The Port Addresses are for Board 0 only and are not
changeable. See the Digiboard manual for Board 1. The
Shared I/O Address is not changeable.
NOTE 3. Use only IRQ 2, 3, 4, or 5 or your personal computer may not work with Access Manage . Whichever IRQ is
used the
Shared I/O Address for this board should be 140H.
Port No.
Comline Nam
(Note 1)
Port Addr
(Note 2)
IRQ
(Notes 2 & 3)
Shared I/O
Addr
(Notes 2&3)
Status Mask
!