Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 374)

D-4 Access Manager 2000 User Manual
CAUTION
It is imperative that the @6FE5.ADF and @6FE6.ADF files are copied
to your configuration disk (Reference Diskette) BEFORE you install
the DigiCHANNEL board. The self-configuring PS/2 system may not
be able to boot up with the board in place and the ADF file missing.
You can’t go back and copy the file with a system that doesn’t boot.
The second procedure, hardware installation, involves installing the
DigiCHANNEL board in your system unit. Refer to your PS/2 hardware
manual for this procedure.
When you have completed the hardware installation, you are ready to use
the disk prepared in the preparation procedure and boot the system to run
the IBM Automatic Configuration program. With the DigiCHANNEL
MC/4 or MC/8 board installed in the system unit, you are now ready to
configure the system to recognize the DigiCHANNEL board.
1. Insert the Reference Diskette into drive A:.
2. Boot the system with the Reference Diskette, containing the ADF
file.
3. Follow the on-screen instructions to automatically reconfigure your
system.
4. Type “Y” when the system tells you that it has found a board it
doesn’t recognize and asks you whether or not it should run
Automatic Configuration.
The @6FE5.ADF and @6FE6.ADF files contain information used
by the automatic configuration program to select interrupts and
addresses for interfacing with the DigiCHANNEL board. The
default settings for the first DigiCHANNEL board are:
• Board Interrupt 3
• Start of Port Addresses DB80h
• Status Port Address DBC0h
!
Hardware
Installation
PS/2 Configuration