Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 381)

Installing a DigiCHANNEL PC/4, PC/8, or PC/16 and
Access Manager 2000 User Manual D-11
CAUTION
Do not install software drivers provided by Digiboard for the PC/4 o
PC/8. Since Access Manager has its own drivers for these boards
using the Digiboard drivers will prevent Access Manager from
working with the PC/4 or PC/8.
Table D-7 Serial Ports for DigiCHANNEL PC/16 in IBM PC, XT, and AT
NOTE 1. The DigiBoard DigiCHANNEL PC/8 was formerly called DigiCHANNEL COM/8. This table gives the
Comline definitions if you install a second DigiCHANNEL PC/8 board. For the first 8 comline definitions, se
Table D-5, “Serial Ports for First DigiCHANNEL PC/4, PC/8 in IBM PC, XT, and AT ,” on pageD-9. Refer to the
appropriate hardware manual for other port addresses, IRQs, Shared I/O addresses, and status masks.
NOTE 2. If your personal computer has a physical COMport before the Digiboards are added, see the following tables
show the numbering sequence for data ports:
Table D-5, “Serial Ports for First DigiCHANNEL PC/4, PC/8 in IBM PC, XT, and AT ,” on pageD-9
• Table D-5, “Serial Ports for First DigiCHANNEL PC/4, PC/8 in IBM PC, XT, and AT ,” on pageD-9
• Table D-6, “Serial Ports for Second DigiCHANNEL PC/8 in IBM PC, XT, and AT ,” on pageD-10.
In this case, the first port of the digiboard would be labeled COM 2.
If your computer has more than one physical COM port before installing the Digiboard, the number of the first
Digiboard port would rise respectively. REMEMBER: no matter how many physical COM ports your computer has,
ALWAYS number the first DigiBoard port address at 100H
NOTE 3. Use only IRQ 2, 3, 4, or 5 or your PC may not work with Access Manage . If IRQ 2 or 4 is used, the Shared
I/O Address for this board should be 189H.
NOTE 4. Install multiple DigiCHANNEL PC/X boards without daisy-chaining. Therefore, you should use the IRQs
shown in these tables and set both boards to Board Identification Number=0 (i.e. jumper J9, pin 2 to pin 3; an
jumper J10, pin 2 to pin 3).
Port No.
Comline Nam
(Note 1)
Port Addr
(Note 2)
IRQ
(Notes 2 & 3)
Shared I/O
Addr
(Notes 2&3)
Status Mask
1 COM2 100H 3H 140H 0H
2 COM3 108H 3H 140H 1H
3 COM4 110H 3H 140H 2H
Port No.
Comline Nam
(Note 2)
Port Addr
IRQ
(Note 3)
Shared I/O
Addr
(Note 3)
Status Mask
!