Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 358)

B-6 Access Manager 2000 User Manual
Table B-3 Modem Configuration for TABS Protocol
Parameter Smartmodem

1200
Switch Position
Option
Smartmodem 2400 AT
Command
DTR status ignored SW1 down Ignores DTR &D0&W
Result code format SW2 down Number V0&W
Result code display SW3 up Codes are not displayed Q1&W
Character echo SW4 down Characters not echoed in
command state
E0&W
Auto-answer SW5 up Enabled S0=1&W
Carrier detect SW6 up Reflects actual result of
attempt to connect
&C1&S1&W
TELCO jack type (Note 2 SW7 up RJ-11, RJ-41S,
RJ-45S
&J0&W
SW7 down RJ-12, RJ-13 &J1&W
Command
recognition SW8 up Disabled Internal jumper set to
disable command
recognition
(Note 3)
Communication standard
at 1200 bps SW9 up Bell 212A B1&W
Response to DTR
transition
(when SW1 is up) SW10 up Hangs up and goes to
command state
Set by SW1 option
NOTE 1. Factory position indicated by boldface.
NOTE 2. Position of SW7 depends on the type of phone jack used. Most installations use an RJ-11 jack (SW7 up).
NOTE 3. The internal jumper should be set to enable command recognition to configure the other options in the table.
After the configuration is complete, power down the modem and set the internal jumper to disable command
recognition.