Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 50)

Access Manager Overview
1-20 Access Manager 2000 User Manual
Loopbacks
This command allows you to activate or deactivate a loopback at the near-
end or far-end CSU, send an inband loop-up or loop-down code to the far-
end CSU, or activate or deactivate an ALL-ONEs test signal to the far-end
CSU. Loopbacks can help you isolate circuit troubles to either the DS1
network or the CSU at either end. For Access System 2000 and
ConnecT1 Plus nodes, the loopback command also lets you activate and
deactivate CSU loopbacks with ANSI T1.403-compatible command
messages.
Select Test
This command is available only when interfacing with an Access System
2000 or ConnecT1 Plus node. It allows you to perform diagnostic tests on
a circuit connected to the node. You can apply a DS1 test signal from an
NCC 2020 or CSU 2010 to the associated circuit for testing. You can
similarly apply a test signal to EQPT (i.e., data port) channels of a DIU
2130 or DIU 2140 for path verification.
The functions under the Database Access menu allow the processing of
DS1 performance data stored in the Access Manager database.
It has the following major branches:
Report
This command analyzes and reports on the performance data stored for
selected network elements over a selected date and time range through the
use of standard filters or user-selected thresholds.
Archive
This command allows you to print performance data records, export them
to a spreadsheet or database system, or delete them.
Database Access
Database Access
Menu
Report
Archiv