Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 164)

Configuring the T1 Network
5-40 Access Manager 2000 User Manual
• The modem is configured for Modem Call/Answer.
• The phone line is connected to the proper modem jack.
• The jack type is correctly configured in the modem.
Direct Connection: If a direct connection is used between Access
Manager and the desired network node, verify that the connecting
cable is wired correctly and that the proper COM port is defined in
the Configuration: Node screen.
ComDesign Multiplexer Connection: If a ComDesign Multiplexer
is used, verify that the Comline is set for access arrangement of
ComDesign or automatic configuration. Also, verify that the access
circuit between the near-end multiplexer and the multiplexer at the
node is operational and that the multiplexer ports are configured
correctly. It is important that you review your Comline
configuration and installation.
A node definition can be edited any time after it has been added to the
Access Manager database. The following steps show you how to edit a
node:
1. From the Main Menu, type C to select the Configuration Menu.
2. Select the Revise Node Definitions option by typing N .
The screen labeled Configuration: Node appears.
3. Type E to select the Edit Node Definitions screen. A Select Node to
Edit screen similar to the one shown below now displays the first
Editing a node