Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 195)

Configuration Options for AS2000 and ConnecT1 Plus
Access Manager 2000 User Manual 5 -71
CAUTION
Set this option to YES only if the CSUs at BOTH ENDS of the circuit
have this option available. Otherwise, set this option to NO . After
making your selection of CSU options, the selected circuit element
configuration options can be updated individually by pressing
.
Or, the entire selected range of elements can be updated
automatically by pressing
.
Configuration Options for AS2000 and ConnecT1 Plus
Elements
ConnecT1 Plus dual-line hardware is a low-cost implementation of the
AS2000 firmware/software specification. The maximum configuration
for a single node is 4 dual-line shelves.
Because of the similarity in the user interface with Access Manager, this
section may use menu samples from either of the two products
interchangeably. Most software features are typical to both products.
Exceptions are noted as follows:
There are some nomenclature differences in the model names and
numbers between the CSUs and DSUs of the two products. These are
summarized in the following table:
Table 5-11 Model Names for AS2000 and ConnecT1 Plus CSUs and
DSUs
The DIU 2140 is unique to AS2000 hardware. Otherwise, each element in
the AS2000 line has a functional counterpart in the ConnecT1 Plus line.
The ConnecT1 Plus functional counterpart to the AS2000’s NCC 2020
(Channel Service Unit) is the CCC 1020, and so forth.
Node Type CSU DSU
AS2000 NCC 2020 DIU 2130
TAC 2010 DIU 2140
ConnecT1 Plus CCC 1020 DIU 1130
TAC 1010 Not applicable
!
F5
F6