Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 378)

D-8 Access Manager 2000 User Manual
Installing a DigiCHANNEL PC/4, PC/8, or PC/16 and
Editing A Comline
The DigiBoard DigiCHANNEL PC/4 and PC/8 boards are designed for
use in IBM PC, XT, and AT personal computers and AT&T 6386. The
PC/16 provides up to 16 serial ports for Access Manager to configure as
comlines. Each PC/8 board provides up to eight comlines, and each PC/4
board provides up to four comlines.
Installing the DigiCHANNEL PC/4, PC/8, or PC/16 board is a three-part
procedure:
1. Configure the DigiCHANNEL board per the strapping option
shown in the following tables:
• For a PC/16 board use Table D-7, “Serial Ports for
DigiCHANNEL PC/16 in IBM PC, XT, and AT ,” on pag eD-11.
• For a PC/4 or PC/8 board use Table D-5, “Serial Ports for First
DigiCHANNEL PC/4, PC/8 in IBM PC, XT, and AT,” on
page D-9
• If a second PC/4 or PC/8 board is used, see Tabl eD-6, “Serial
Ports for Second DigiCHANNEL PC/8 in IBM PC, XT, and
AT,” on pa geD-10
2. Install the board(s) in your personal computer (PC). Refer to your
computer manual for these instructions.
3. Configure Access Manager comlines to use the DigiCHANNEL
boards, using the parameters in Tables E-5, E-6, and E-7.
Note: Your Digiboard user’s manual refers to the Shared I/O Address
(TablesD-5, D-6 and D-7) as the Status Register Address. Also,
the Port Address in these tables is referred to as the I/O Port
Address.