Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 373)

Installing a DigiCHANNEL MC/4 or MC/8 and Editing
Access Manager 2000 User Manual D-3
Installing a DigiCHANNEL MC/4 or MC/8 and Editing a
Comline
The DigiBoard DigiCHANNEL MC/4 and MC/8 boards are designed for
use in IBM PS/2 Micro Channel personal computers. Each MC/8 board
provides up to eight Comline ports. The MC/4 boards provide up to four
Comline ports.
Installing the DigiCHANNEL MC/4 or MC/8 board is a four-part
procedure:
1. Preparation
2. Hardware Installation
3. PS/2 Configuration
4. Configuring Access Manager.
Each part is relatively simple in itself, but you must perform all four
procedures sequentially for your DigiCHANNEL MC/4 or MC/8 board to
work.
Copy the DigiBoard-supplied @6FE5.ADF and @6FE6.ADF files from
your DigiWARE disk to your working copy of the Reference Diskette.
This disk is used later by the System Configuration procedure. The ADF
file contains the information that the system needs to automatically
configure the DigiCHANNEL MC/4 or MC/8 board. The ADF file is in
the subdirectory CONF on the DigiWARE disk that comes with the
DigiCHANNEL board.
1. Make a working (backup) copy of your original IBM Reference
Diskette, and store the original in a safe place. The backup disk
must be a formatted high-density 1.44-megabyte 3.5-inch diskette.
At this time, also make a copy of your DigiWARE disk, and store
the original in a safe place.
2. Copy the @6FE5.ADF and @6FE.ADF files from your DigiBoard
DigiWARE disk to your working copy of the Reference Diskette.
The ADF file contains the information that the system needs to
know about the DigiCHANNEL MC/4 or MC/8 board.
Preparation