Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 92)

Configuring Access Manager
4-6 Access Manager 2000 User Manual
Report output destination
The Printer Filename option specifies a destination for the report
output. You can print to either:
■
a parallel port (LPT1 or LPT2), or
■
a disk file
You must use the DOS file naming convention to enter a file name or a
full path name for a disk file. The
Printer Filename field allows
you to enter up to 20 characters: 8 characters for the file’s name and the
remaining 12 characters for the path. If the file name were
PRINT1.DOC
and the path were C:\AM2000\ , the entire filename would be
C:\AM2000\PRINT1.DOC .
You should include the full DOS path even though it is not required.
■
If a non-reserved name is specified, the report is saved to a disk file
and may be accessed later.
■
If a full DOS path is not included, the file is placed in the current
directory.
■
If a filename is specified and you press to save the definition,
a file is created on disk with the name specified and zero bytes
assigned. This is done to verify that the definition is correct and the
file can be created.
■
If the filename NUL or NONE is used, the output is discarded.
■
If no printer is to be attached, then NONE should be entered to
avoid the PC attempting to print to a non-existent printer and
“freezing” in the process.
Enter a filename and press .
Printer Type
Printer Type selects the type of printer used to print the data. This
field is only valid when LPT1 or LPT2 is entered for the Printer
Filename option.
Access Manager supplies drivers for five printers, but only one of the
predefined printer types can be entered in this field at a time.
The only difference in the five printer types supported is in the characters
used to program the printers for condensed (compressed) mode and to
F5
Enter