Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 220)

Configuring the T1 Network
5-96 Access Manager 2000 User Manual
EQP Speed
Type the transmission speed for each port on the next line of the menu.
This rate must be 56 kbps, 64 kbps, or a multiple of either rate. The total
(aggregate) rate for the data ports of all DIU 2130s and DIU 1130s
connected to a CSU cannot exceed 1.536 Mbps. This parameter is
informational only.
64K Mode
If you set this option to YES , each channel of the DS1 line carries 64 kbps
of data. If you set this option to NO (default setting), each DS0 channel
carries 56 kbps of data. If the data rate of your equipment is a multiple of
56 kbps, set this option to
NO . If it is a multiple of 64 kbps, set this option
to YES .
Loop
If you enable this option (Y), the DIU responds to loopback commands.
Scramble
The customer data on a DIU data port may require protection from
unauthorized access.
If scrambling is required, set this option to YES on each equipment (EQP)
port. This setting allows the DIU to randomize the data before
multiplexing and sending it to the CSU.
If scrambling is not required, set this option to NO (default setting) on the
associated DIU data port.
Be sure to set the Scramble option the same way at the far-end NCC,
DIU 1130 so that it can restore the original customer data upon receiving
it.
EQP Clock
Select the timing source for the incoming data from the customer data
equipment. This can be either the
TT (Transmit Timing) signal from the
data equipment or an internal clock (either ST or inverted ST) generated
by the DIU. If the
TT lead is not available from the data equipment,
select either ST or INVERT ST to have the DIU clock the data in. The
ST choice depends on which clock signal transition is to be used for data