Analyzer menu – INFICON Explorer Portable Gas Chromatograph User Manual
Page 150
SiteChart
Software
148
Analyzer Menu
Setup
The
Setup
command allows you to enter a tag and provides access to the auto cycle
settings.
A tag may be used to identify a certain sampling location or a certain sample in the
datalogger. You can enter a tag to indicate a change of location, a change in
personnel or a change in method.
To enter a tag:
1. Open the Analyzer menu and select
Setup
.
2. Enter a tag.
The tag can use up to 10 characters.
3. Click
OK
to confirm the tag.
The tag you enter here will identify both GC and TVOC analyses. You can enter a
new tag for every analysis or you can enter a single tag for a group of analyses.
Auto Cycling Operation
Auto operation allows you to set up
Explorer to take samples automatically. You
must use loop injections for auto analyzing. If more than one column is required to
complete an analysis, then each column will be sampled in order. If each column
has different chromatographic settings,
Explorer will adjust its settings between
analyses. You can also configure the instrument to perform a preset number of
analyses.