INFICON Guardian EIES Controller - Manual (Page 102)

4 - 10
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
3 Now attach each leg of the fiber optic bundle to an EIES detector. See Figure
4-10 .
Figure 4-10 Attaching Fiber Ends to Detectors
1 Thread an 070-1620 Retaining Ring part way into the 070-1622 Lens Tube so
that it is approximately 0.45 in. (1 cm) deep into the lens tube.
2 Insert the 782-900-035-xxx optical filter into the lens tube with the arrow on the
filter pointing to the PMT Detector.
3 Insert the 782-020-042 Fiber Optic Adapter and secure the filter and adapter
with a second 070-1620 Retaining Ring. Tighten the retaining ring using the
070-1628 tool supplied with the Guardian Ship Kit 782-703-G1.
All three setscrews in the fiber optic adapter should be accessible. Adjust the
location of the first retaining ring as necessary to provide access to all set
screws in the Fiber Optic Adapter.
4 Finally, insert the fiber end into the fiber optic adapter and secure with three set
screws, do not overtighten
782-900-030
PMT
Detector
Lens
Tube
070-1622
Retaining Ring
Fiber Optic
Single Strand
Fiber Optic
Adapter
782-020-042 Optical
Filter