INFICON Guardian EIES Controller - Manual (Page 55)

3 - 3
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
3.2 Installation
NOTE: The EIES program may be installed and used in Simulate mode without an
EIES-IV Guardian controller. This is useful for learning the software, and
for off-line process development.
To install the EIES software, insert the INFICON Program CD-ROM. If the setup
program does not start automatically, click Start, then Run, then type
<d>:UtilityDisk (where <d> is the drive you are using). The Program Disk main
menu should appear.
On the program disk menu, see Figure 3-2 , click EIES Guardian Deposition
Controller, then click on EIES Guardian Software and follow the directions given
there. When installation is complete, you may be prompted to restart the computer.
Figure 3-2 Program Disk Menu
To start the EIES program, click the EIES desktop icon, or click Start, Programs,
INFICON, then EIES. The EIES program main screen will be displayed.
NOTE: The following description covers operation without a Guardian connected.
If a Guardian is to be connected at this time, select the communications
interface as described at
section 3.8.5, Comm Tab, on page 3-35 before
proceeding. To make RS232 connections, connect a serial cable from the
Guardian serial port to the computer’s serial port. The cable required is a
DB9 female-to-male. Guardian baud rate is fixed at 115,200 and the
communications format is No Parity, 8 bits, 1 stop bit. To make ethernet
connections, connect an ethernet cable and set the IP Address as
described at
section 3.8.5, Comm Tab, on page 3-35 .