INFICON Guardian EIES Controller - Manual (Page 91)

3 - 39
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
3.9.2.1 Graph Setup
The Graph Setup dialog box provides access to the most commonly used graph
setup parameters. It also provides total control of graph setup, using the Advanced
Property Editor.
Figure 3-31 View Setup
Title: The caption that appears at the top of the graph window and on the main
dialog box's Graph menu. However, the graph's setup properties are always stored
on disk as Graph 1 to Graph 4.
Data: Selects which of the seven possible data sources are used for this graph —
Rate, Filtered Rate, Rate Ratio, Dev(iation), Power, Total, or Sensor data. Sensor
data displays the main flux and gas compensating signals for each detector.
Help: Shows the graph setup help dialog box if the Advanced checkbox is not
checked. If the Advanced checkbox is checked, shows advanced Property Editor
help.
Close: Closes the Graph Edit dialog box.
3.9.2.1.1 Show Channel — Axis
Channel 1 to 8: Selects the EIES channels to be graphed. If the channel is used
in a layer, and the channel is checked here, its data is displayed. If the channel is
not assigned to a layer, the show channel selection for that channel is ignored.
Left: The data for this channel is referenced to the left axis of the graph. When
Sensor Data is selected (see above) the left axis shows the main flux sensor.
Right: The data for this channel is referenced to the right axis of the graph. When
Sensor Data is selected (see above) the right axis shows the gas compensating
sensor.