INFICON Guardian EIES Controller - Manual (Page 68)

3 - 16
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
3.6 Edit Layer
A Layer establishes the desired rate and thickness (plus a few other parameters)
for a deposited film. The Edit Layer dialog box, see
Figure 3-14 , can be accessed
by clicking a channel Edit button on the Main Screen, or by highlighting a layer and
clicking Edit on the Edit Process dialog box.
Figure 3-14 Edit Layer Dialog Box
NOTE: The Channel and Output settings can only be changed by accessing Edit
Layer from the Edit Process dialog box when the process is stopped.
Channel (1 to 8) : The channel that displays this layer's readings on the main
screen. Typically this is the same as the detector input channel (labeled MODULE
1 to MODULE 8) on the Guardian controller. If a QCM or analog input is used as
the input for this layer, it is selected on Channel Input of the Film Cal. tab (see
section 3.7.3 on page 3-28 ).
Output (1 to 8): The Guardian Control Output that is used when depositing this
layer.
Film: This is the most important layer parameter. It establishes the material to be
deposited, and many of the instrument setup parameters associated with that
material. Select the desired film from the Film drop-down menu. This selection
determines the values that are displayed on the Film and Film Cal. tabs of the Edit
Layer dialog box.