INFICON Guardian EIES Controller - Manual (Page 48)

2 - 24
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
Figure 2-24 Film Tab Full Scale Voltage
Select the Film Cal(ibration) tab, and verify that the PMT volts setting is about 700.
Figure 2-25 PMT Voltage Setting
If you are using QCM calibration of the EIES measurements, select the proper
QCM Sensor# and enter the material Density and ZFactor (Z-Ratio) (see
Appendix
B ). For now, it is probably best to disable QCM calibration by setting Cal QCM# to
None.