Lenze E94AYAE SM301 - Manual (Page 35)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
35
3 Safe configuration
3.7 Safe inputs
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of "Safe inputs" parameter group:
Sensor type/sensor function
The sensor type and function can be parameterised.

Tip!
Detailed information on sensor inputs, active and passive sensors can be found in the
manual for the safety module.
Parameter Info Lenze setting
Value Unit
C15030/1...4 SD-In1...4 sensor type Input deactivated
C15031/1...4 SD-In1...4 sensor function Free assignment
C15032/1...4 SD-In1...4 free assignment STO
C15033/1...4 SD-In1...4 discrepancy time 10 ms
C15034/1...4 SD-In1...4 input delay 0 ms

Note!
If an error (e.g. a discrepancy error) occurs at a safe input to which the "operation mode
selector" sensor function is assigned, the corresponding input is valued as OFF state.
• By this, normal operation is activated up to SM301 V1.2 .
• From SM301 V1.3 the operating mode in the case of LOW level at the safe input can
be parameterised via C15202 .
• The "Module Error ME" LED blinks, STO is not tripped.
• Special operation can only be selected again if the error has been eliminated and
acknowledged.