Lenze E94AYAE SM301 - Manual (Page 83)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
83
5 Parameter reference
5.1 Parameter list | C15113
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C15113
Parameter | Name:
C15113 | S bus: Filter control data
Data type: BITFIELD_32
Index: 9462
d
= 24F6
h
Bit-coded selection of the active bits in the safety bus control data.
 Safety bus
Setting range Lenze setting
0x00000000 0xFFFFFFFF 0x01830BFF (decimal: 25365503)
Value is bit-coded: ( = bit set) Info
Bit 0  STO  Safe torque off
Bit 1  SS1  Safe stop 1
Bit 2  SS2  Safe stop 2
Bit 3  SLS1  Safely limited speed 1
Bit 4  SLS2  Safely limited speed 2 (from V1.1)
Bit 5  SLS3  Safely limited speed 3 (from V1.1)
Bit 6  SLS4  Safely limited speed 4 (from V1.1)
Bit 7  SDIpos  Safe positive direction (from V1.3)
Bit 8  SDIneg  Safe negative direction (from V1.3)
Bit 9  ES  Safe enable switch
Bit 10  Reserved
Bit 11  OMS
 Safe operation mode selector
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  Reserved
Bit 16  PS_AIS
Restart acknowledgement via safety bus
Bit 17  PS_AIE Error acknowledgement via safety bus
Bit 18  Reserved
Bit 19  Reserved
Bit 20  Reserved
Bit 21  Reserved
Bit 22  Reserved
Bit 23  SSE
 Emergency stop function
Bit 24  SD-Out1  Safe output
Bit 25  Reserved
Bit 26  Reserved
Bit 27  Reserved
Bit 28  Reserved
Bit 29  Reserved
Bit 30  Reserved
Bit 31  Reserved
 Read access  Write access  CINH  PLC-STOP  No transfer