Lenze E94AYAE SM301 - Manual (Page 85)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
85
5 Parameter reference
5.1 Parameter list | C15200
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C15200
C15201
C15202
C15203
Parameter | Name:
C15200 | OMS: Stop function
Data type: UNSIGNED_8
Index: 9375
d
= 249F
h
Selection of the stop function during special operation.
 Operation mode selection
Selection list (Lenze setting printed in bold) Info
0 STO  Safe torque off
1 SS1  Safe stop 1
2 SS2  Safe stop 2
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15201 | OMS: Motion function
Data type: UNSIGNED_8
Index: 9374
d
= 249E
h
Selection of the motion function during special operation.
 Operation mode selection
Selection list (Lenze setting printed in bold) Info
3 SLS1  Safely limited speed 1
4 SLS2  Safely limited speed 2 (from V1.1)
5 SLS3  Safely limited speed 3 (from V1.1)
6 SLS4  Safely limited speed 4 (from V1.1)
11 Free traversing
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15202 | OMS: Function at LOW level
Data type: UNSIGNED_8
Index: 9373
d
= 249D
h
From V1.3
 Danger!
If the operation mode selector is implemented via a safe input, the operating mode for the LOW level must be
selected carefully. According to the closed-circuit principle, there must not arise any additional danger from normal
or special operation in the corresponding application.
For detailed information, please see the manual for the safety module.
 Safe operation mode selector
Selection list (Lenze setting printed in bold) Info
0 Normal operation  Operation mode selection
1 Special operation
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15203 | SLI: Safely limited increment
Data type: UNSIGNED_32
Index: 9372
d
= 249C
h
From V1.4
Number of increments for safely limited increment.
• Value "0" deactivates the SLI function.
 Operation mode selection
Setting range (min. value | unit | max. value) Lenze setting
0 Incr. 2147483647 1 inc.
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1