Lenze E94AYAE SM301 - Manual (Page 67)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
67
4 Safe parameter transfer
4.2 Read safe data from device
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2 Read safe data from device

How to upload the parameter set:
1. Unless there is an online connection, establish an online connection to the device.
2. Go to the Safe transfer dialog box and click Upload.
• A confirmation prompt appears asking whether the parameter is really to be uploaded
from the device.
3. Answer the confirmation prompt with Yes to continue the action.
If you are not yet registered as user, first the Password entry dialog box is displayed.
4. Enter the device password and confirm with OK.
• Unless an individual password has been defined, enter the standard password which is
indicated in the manual for the safety module.
• After the password has been entered, you are registered as user for a period of 30
minutes. Within this period, the password does not need to be entered again for calling
a password-protected function if the online connection to the device remains
established without any interruptions.
After the registration, the parameter set is uploaded from the device, and a status message
displays whether the action was successful.
5. Confirm the status message with OK.

Note!
After the parameter set has been transmitted, make a check of the item designation and
a check/acceptance of the safety functions!
Detailed information on the check/acceptance can be found in the manual for the safety
module in the "Acceptance" chapter.

Note!
This function serves to overwrite the parameter settings in the »Engineer« with the
current settings of the safety module!
Only a valid parameter set can be read back from the safety module.