Lenze E94AYAE SM301 - Manual (Page 79)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
79
5 Parameter reference
5.1 Parameter list | C15051
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C15051
Parameter | Name:
C15051 | SD-Out switching condition
Data type: BITFIELD_32
Index: 9524
d
= 2534
h
Bit-coded selection of the conditions for switching the safe output.
 Safe output
Setting range
0x00000000
0xFFFFFFFF
Value is bit-coded: ( = bit set) Info
Bit 0  STO is active  Safe torque off
Bit 1  STO active - neg. logic  Safe torque off
Bit 2  SS1 active  Safe stop 1
Bit 3  SS1 active - neg. logic  Safe stop 1
Bit 4  SS2 active  Safe stop 2
Bit 5  SS2 active - neg. logic  Safe stop 2
Bit 6  SLS1 active  Safely limited speed 1
Bit 7  SLS1 active - neg. logic  Safely limited speed 1
Bit 8  SLS2 active  Safely limited speed 2 (from V1.1)
Bit 9  SLS2 active - neg. logic  Safely limited speed 2 (from V1.1)
Bit 10  SLS3 active  Safely limited speed 3 (from V1.1)
Bit 11  SLS3 active - neg. logic  Safely limited speed 3 (from V1.1)
Bit 12  SLS4 active  Safely limited speed 4 (from V1.1)
Bit 13  SLS4 active - neg. logic  Safely limited speed 4 (from V1.1)
Bit 14  SDIpos active  Safe positive direction (from V1.3)
Bit 15  SDIpos active neg. logic  Safe positive direction (from V1.3)
Bit 16  SDIneg active  Safe negative direction (from V1.3)
Bit 17  SDIneg active neg. logic  Safe negative direction (from V1.3)
Bit 18  ES active  Safe enable switch
Bit 19  ES active - neg. logic  Safe enable switch
Bit 20  SLI active  Safely limited increment (from V1.4)
Bit 21  SLI active - neg. logic  Safely limited increment (from V1.4)
Bit 22  OMS  Safe operation mode selector
Bit 23  OMS neg. logic  Safe operation mode selector
Bit 24  Reserved
Bit 25  Reserved
Bit 26  Reserved
Bit 27  Reserved
Bit 28  Reserved
Bit 29  Reserved
Bit 30  Reserved
Bit 31  Reserved
Subcodes Lenze setting Info
C15051/1 0x00000000 SD-Out1 switching condition
 Read access  Write access  CINH  PLC-STOP  No transfer