Wasp Barcode Inventory Control - Manual (Page 114)

InventoryControl Printable Help
5. Press ENTER to access a new line and enter another Item, then repeat the steps above. Your
screen will appear similar to the following after pressing ENTER:
Note: The cost will be calculated and updated based on your selections on this tab unless you have
checked the Do Not Override Cost on the General Tab checkbox located at the bottom of the
Assembly Information tab.
7.2.5 Additional Information Tab:
When you have finished entering information on the Assembly tab, click the Additional tab. The
Additional Information tab provides optional fields where other information about the Item can be
recorded. An example of this tab is shown below:
99