Wasp Barcode Inventory Control - Manual (Page 323)

InventoryControl Printable Help
19.7 WDT2200 - Resetting the Device
The following steps can be performed to clear all data from the WDT2200.
Any inventory transactions not yet uploaded to the PC will be lost if the PDT is reset per the following
instructions:
1) Power off the WDT2200 by pressing and holding the power key until no text is displayed
on the screen.
2) With the WDT2200 powered off...
...hold down the CMD and left-arrow keys, then press the power key.
The Start Menu will be displayed:
If you do not see the Start Menu shown above, power off the PDT and repeat the key sequence
described above.
3) From the Start Menu, select 3. COLD START by pressing the 3 key on the PDT.
4) Respond with 1=YES to delete all data by pressing the 1 key on the PDT. The WDT2200 will
be Cold Started and all data will be lost.
308