Wasp Barcode Inventory Control - Manual (Page 338)

InventoryControl Printable Help
While looping on Item #, all that is required for each transaction here are values for Qty and Item #. The
Count is incremented each time an Add is done while looping.
Press the ENT key to submit the Add transaction and continue looping
or
Press the F4 key to exit the loop.
When looping on Item #, all items entered should have the same Tracked By requirements. If a
different Tracked By field is required, you will be prompted to enter the information before continuing.
Looping will need to be reset.
Looping on a Tracked By (other than Serial Number)
Here, for example, F3 was pressed when prompted for Pallet while doing an Add for this Item:
Add
123
Monitor
Pallet:
*
ESC=Cancel
F1=Prev F4=Next
An asterisk (*) indicates the intention to do more than one Add for this Item #, for more than one Pallet.
Values entered for Item #, Location, PO, Supplier, and any other Tracked By fields will remain locked
while looping on Pallet, after entering them for the first Add:
123
Qty:
Pallet: *
Total Qty:
30.00000
F4=Done
Above, having entered a value for Pallet and a value of 30 for Qty on the previous screen for the first
Add, this screen is ready to receive inputs for another Add. Item #, Location, PO and Supplier values
for this second Add will be the same as those supplied at the beginning of the loop.
While looping on this Tracked By field, all that is required for each Add are values for Qty and Pallet.
The Total Qty is incremented each time an Add is submitted while looping.
323