Wasp Barcode Inventory Control - Manual (Page 378)

InventoryControl Printable Help
Note: You can press the F2 key to view the last Serial Number entered.
If the Allow Negative Quantities on Mobile Devices options is disabled, and a Tracked By
value that does not match a value associated with inventory available at the previously specified
Location is entered, the following screen will be displayed:
No item with this tr
ackby specific in st
ock
ESC=Exit
If Allow Negative Quantities on Mobile Devices is enabled, any Tracked By value is allowed.
Press Esc to Exit the error message and then provide a Tracked By value that matches inventory
in stock at the specified Location.
Looping on Serial Number:
Fields can be looped, or pinned, by pressing the F3 key. An asterisk displays next to the looped field.
If track by Serial Number is enabled for this Item, the Qty field will be set to 1. A quantity of one is
assumed for each Serial Number. Looping will determine the final count for this Add transaction, as you
scan (or key in) one or more Serial Numbers for this Item:
1000066
Qty:1
SN: *
Count:0
F4=Done
As each SN is keyed in or scanned, the Count will be increased. Press ENT after inputting each serial
number.
Press F4 after entering the last Serial Number to the Remove screen.
Notes:
 When an Item is tracked by Serial Number, you can only loop on Serial Number.
 When an Item is not Tracked By Serial Number, you can use F3 to designate a field that will be
used for looping. The values in every field except Qty will remain locked while looping.
Looping on Location:
Fields can be looped, or pinned, by pressing the F3 key.
363