Wasp Barcode Inventory Control - Manual (Page 336)

InventoryControl Printable Help
Looping on Serial Number:
Fields can be looped, or pinned, by pressing the F3 key. An asterisk displays next to the looped field.
If track by Serial Number is enabled for this Item, the Qty field will be set to 1. A quantity of one is
assumed for each Serial Number. Looping will determine the final count for this Add transaction, as you
scan (or key in) one or more Serial Numbers for this Item:
1000066
Qty:1
SN: *
Count:0
F4=Done
As each SN is keyed in or scanned, the Count will be increased. Press ENT after inputting each serial
number.
Press F4 after entering the last Serial Number to the Add screen.
Notes:
 When an Item is tracked by Serial Number, you can only loop on Serial Number.
 When an Item is not Tracked By Serial Number, you can use F3 to designate a field that will be
used for looping. The values in every field except Qty will remain locked while looping.
Looping on Location:
Fields can be looped, or pinned, by pressing the F3 key.
In the example below the F3 key was pressed when prompted for Location while doing an Add for this
Item:
Add
123
Monitor
Location:
*
ESC=Cancel
F1=Prev F4=Next
An asterisk (*) indicates the intention to do more than one Add for this Item #, to more than one
Location. Values entered for Item #, PO and Supplier, if any, will remain locked while looping on
Location after entering them for the first Add. Tracking fields are needed only for any Tracked By options
enabled for the Item entered.
In the example below F3 was pressed when prompted for Location and then values for Location, PO,
Supplier, any Tracked By's, and a Qty of 10 were entered, this screen is ready to receive inputs for
321