Wasp Barcode Inventory Control - Manual (Page 160)

InventoryControl Printable Help
To prevent fields from clearing, click the Pushpin button located to the right of the field you
want to lock for subsequent transactions. This is helpful when you have to perform multiple
removes at one Location, for example. Pushpins can be used to lock the values in all but one
required field so that a scanner can be used to rapidly remove inventory just by repeatedly
scanning barcodes into that field. (The Move button does not have to clicked between each scan
to post these remove transactions to the Pending Transaction List.)
Clicking the button will unlock the field.
3. Complete the Item Fields: To Move inventory, first enter the Item Number of the item you want
to move. To enter an Item Number, you can type or scan the value into the field, or you can use
the drop down list to select an existing item from the 10 items shown or use <more> to select an
item from the Item List.
When you enter an item number, the Item Number field is populated as well as the Description
and the following fields are enabled:
 From Location (filtered by Site)
 Quantity (unless the item is Tracked By serial number, then the quantity defaults to 1
and cannot be changed),
 To Location
 Any of the associated Track By fields: Serial Number, Date Code, Lot or Pallet. A
Tracked By field is enabled or disabled at the time the Item is created.
 Notes
Below is an example of the Move screen with the fields enabled:
145