Wasp Barcode Inventory Control - Manual (Page 360)

InventoryControl Printable Help
Note: If the Allow Negative Quantities on Mobile Devices Option is disabled on the Options
screen, you will receive a warning message if you attempt to Move quantity from a location that
does not exist in the PDT database. The Allow Negative option must be set on the PC prior to
creating the mobile database. You can check the state of this option on the PDT by viewing the
PDT About screen.
New Source Site From locations can only be created during Move when the Allow Negative
Quantities on Mobile Devices option is enabled. Please see the
Options Screen topic for more
information on this option.
When a From location value has been entered, press F4 or ENT to advance to the To location
field.
4. Provide the required To location value.
Move
1000052
Fence-Rail
To:
A2
ESC=Cancel
F1=Prev F4=Next
As shown below, if a From or To Location value is entered that's not currently in the database,
you will be prompted to accept or reject the entry as a new value to be added to the database for
the
Source or Destination Site shown.
Site:
Warehouse 2
New Location:
Area 2
ENT=OK
ESC=Cancel
If you are prompted to confirm a new Location that you believe should already exist in the
database at that Site, press ESC to cancel, then return to the Main Menu to check Site Config.
If the From location you entered exists only at a Site other than the currently selected Source
Site, InventoryControl must treat that value as a new Location for the Source Site. Select a
different Source Site in Site Config if that's where you intended to perform this transaction.
Press the ENT key to accept the new value or the ESC key to Cancel the creation of a new
Location.
5. If this Item does not have Tracked By enabled for the Date Code, Pallet or Lot fields, a screen
like the one below will be shown, prompting the entry of Qty.
Move
1000052
Fence-Rail
Qty:
ESC=Cancel
F1=Prev F4=Next
345