Wasp Barcode Inventory Control - Manual (Page 320)

InventoryControl Printable Help
The following conditions must be true before proceeding:
 The WDT2200 must be powered on and connected to the PC's serial port.
 The InventoryControl Log On screen must be displayed on the PDT. Logout if the PDT is
still running the InventoryControl program.
If you attempt to Receive Data From PDT while InventoryControl is running on the PDT, you will
receive a message that you need to logout of the program on the PDT, then try again.
After logging out of inventoryControl on the PDT, click the Back button to restart the dialog.
Click the Next button to start the transfer.
If no inventory transactions were performed on the PDT since the last time data was transferred to or
from the PDT, the following message will be displayed:
If transactions were received from the PDT successfully, you will receive a confirmation message.
Click Finish to close this dialog and return to InventoryControl
or
Click the Mobile Device to PC tab or the Back button to restart the dialog if you want to receive
data from another PDT.
305