Wasp Barcode Inventory Control - Manual (Page 353)

InventoryControl Printable Help
Site:
Warehouse 2
New Location:
Area 7
ENT=OK
ESC=Cancel
If you are prompted to confirm a new Location that you believe should already exist in the
database, press the ESC key to cancel, then return to the Main Menu to check Site Config. If
the Location you entered exists only at a Site other than the currently selected Source Site,
InventoryControl must treat that value as a new Location for the Source Site. Select a different
Source Site in Site Config if that's where you intended to perform this transaction.
Press the ENT key to accept the new value or the ESC key to Cancel the creation of a new
Location.
4. If this Item does not have Tracked By enabled for the Date Code, Pallet or Lot fields, a screen
like the one above will be shown, prompting the entry of Qty.
Audit
100007
Monitor
Qty:
ESC=Cancel
F1=Prev F4=Next
Key in the inventory quantity at this Location and press ENT or F4 to complete the Audit
transaction. The Qty value entered must be numeric and it must be greater than or equal to zero.
If this Item does have Tracked By enabled for Date Code, Pallet or Lot fields, screens like the
one below will be shown, expecting input for each Tracked By field that's enabled.
Audit
100007
Monitor
Date Code:
ESC=Cancel
F1=Prev F4=Next
Key in or scan values for each of the Tracked By fields, pressing F4 to advance to the next data
entry field.
If you press F4 to advance to the next data entry field, without first inputting a required Tracked
By value, a screen similar to the following will be displayed:
Please scan or key
in Date Code
ESC=Exit
338