Wasp Barcode Inventory Control - Manual (Page 344)

InventoryControl Printable Help
19.15 WDT2200 - Adjusting Inventory
The Adjust function allows you to modify the quantity of existing items. Adjust is like a "mini" Audit and
will update the quantity using FIFO (First In First Out) to make the total equal to the quantity you enter
here. The Adjust function is useful if too much or too little quantity is accidentally entered for an item (on
a mobile device, for example), inventory is lost, found, broken, etc. and you need to quickly correct the
quantity for that item. Adjusting is different from an Audit in that the Audit function makes other functions
of the software, such as adding inventory, unavailable to ensure inventory is not added or removed while
you are doing the counts. All features are still available when adjusting inventory.
The Allow Negative Quantities option applies to batch devices only. Mobile devices that are
communicating with the database via a wireless connection will not allow negative quantity
transactions regardless of the option settings.
Notes:
 An item tracked by Serial Number which has been Checked-Out can not be Adjusted.
 Inventory adjustments can also be made at the PC using the Adjust screen.
 Make sure the PDT's date and time are set correctly before performing inventory transactions.
 Source and/or Destination sites are not specified during on the database you sent to the PDT, the
following message will be displayed the first time you attempt to perform an inventory transaction
on the PDT:
Please use the Site
Config function to
Select Source and
Destination Sites.
ESC=Exit
Press the Escape key to return to the Main Menu, then select the 6 key to go to the Site Config
function. For more information on configuring sites on the PDT, please refer to the topic,
WDT2200 - Configuring Sites .
The following topics are covered in this section:
Adjusting Inventory
Looping on Serial Number
Looping on Location
Looping on Item Number
Looping on a Track By (other than Serial Number)
329