Wasp Barcode Inventory Control - Manual (Page 453)

InventoryControl Printable Help
the Destination Site. The Dest Site field is used as the default for Move (to).
, you will see that the appropriate fields are pre-populated with
the selected sites in all the device's InventoryControl screens.
3. Enter
4. Tap
OK.
After you have configured the Sites
20.11.3 Windows Mobile Device - Pinning Fields
"Pinning" can be used to lock values you have entered in any field. Pinning enables you to enter repea
information rapidly without having to re-enter repetitive data. After a field is pinned, you can manually
enter data, or you can use a scanner to rapidly Add, Remove, Move, Adjust, etc. by repeate ted
dly scanning
n pin the Item #
dd.
Note: Before pinning a field, make sure the data you want pinned in the field is entered. Once you pin the
field, you cannot change the data entered in the field until the field is unpinned.
Remember that once you close a creen, the field will no longer be pinned when you re-open that screen.
To pin a field, tap the field name.
barcodes.
For example, if you need to add the same inventory Item Number multiple times, you ca
field and perform continuous Adds without having to re-enter the Item Number for each A
s
Pinning Fields:
The entire field turns grey. This indicates the field is now pinned. Whatever information that has been
entered in this field will remain until the screen is closed.
e
Unpinning Fields:
To unpin the field, click the field name again. The field will no longer be grey, and you may now chang
the information in the field.
438