Wasp Barcode Inventory Control - Manual (Page 380)

InventoryControl Printable Help
Above, the asterisk (*) indicates the intention to loop on Item #. Values entered for Location, PO,
Supplier and any Tracked By fields (other than Serial Number) will remain locked after entering them for
the first Remove:
Qty:
Item #:
Count:25
F4=Done
Above, having pressed F3 when prompted for Item # and then having entered the item number and
values for Location, PO, Supplier, any Tracked By's, and a value of 25 for Qty, this screen is ready to
receive Qty and Item # inputs for the second Remove. The Location, PO, Supplier, and any Tracked
By values just specified will be used with every Remove transaction entered until F4 is used to exit the
loop.
While looping on Item #, all that is required for each transaction here are values for Qty and Item #. The
Count is incremented each time a Remove is done while looping.
Press the ENT key to submit the Remove transaction and continue looping
or
Press the F4 key to exit the loop.
When looping on Item #, all items entered should have the same Tracked By requirements. If a
different Tracked By field is required, you will be prompted to enter the information before continuing.
Looping will need to be reset.
Looping on a Tracked By (other than Serial Number)
Here, for example, F3 was pressed when prompted for Pallet while doing a Remove for this Item:
Remove
123
Monitor
Pallet: *
ESC=Cancel
F1=Prev F4=Next
An asterisk (*) indicates the intention to do more than one Remove for this Item #, for more than one
Pallet. Values entered for Item #, Location, PO, Supplier, and any other Tracked By fields will remain
locked while looping on Pallet, after entering them for the first Remove:
365