Wasp Barcode Inventory Control - Manual (Page 398)

InventoryControl Printable Help
Looping on Location:
Fields can be looped, or pinned, by pressing the F3 key.
In the example below the F3 key was pressed when prompted for Location while doing a Receive for this
Item:
Receive
123
Monitor
Location: *
ESC=Cancel
F1=Prev F4=Next
An asterisk (*) indicates the intention to do more than one Receive for this Item #, to more than one
Location. Values entered for Item #, PO and Supplier, if any, will remain locked while looping on
Location after entering them for the first Add. Tracking fields are needed only for any Tracked By options
enabled for the Item entered.
In the example below F3 was pressed when prompted for Location and then values for Location, PO,
Supplier, any Tracked By's, and a Qty of 10 were entered, this screen is ready to receive inputs for
another Pick. PO, Supplier and Tracked By values, if any, for this second Pick will be the same as those
supplied at the beginning of the loop, if any.
123
Qty:
Location:
Total Qty:
10.00000
F4=Done
While looping on Location, all that is required for each Receive are values for Qty and Location. The
Total Qty field is incremented each time a Receive is submitted while looping.
Press the ENT key to submit the Receive transaction and continue looping or press the F4 key to exit the
loop.
Looping on Item Number:
Fields can be looped, or pinned, by pressing the F3 key.
In the following example, F3 was pressed when prompted for Item #:
383