Wasp Barcode Inventory Control - Manual (Page 364)

InventoryControl Printable Help
Above, having pressed F3 when prompted for Item # and then having entered the item number and
values for Location, PO, Supplier, any Tracked By's, and a value of 25 for Qty, this screen is ready to
receive Qty and Item # inputs for the second Move. The Location, PO, Supplier, and any Tracked By
values just specified will be used with every Move transaction entered until F4 is used to exit the loop.
While looping on Item #, all that is required for each transaction here are values for Qty and Item #. The
Count is incremented each time an Move is done while looping.
Press the ENT key to submit the Move transaction and continue looping
or
Press the F4 key to exit the loop.
When looping on Item #, all items entered should have the same Tracked By requirements. If a
different Tracked By field is required, you will be prompted to enter the information before continuing.
Looping will need to be reset.
Looping on a Tracked By (other than Serial Number)
Here, for example, F3 was pressed when prompted for Pallet while doing an Move for this Item:
Move
123
Monitor
Pallet:
*
ESC=Cancel
F1=Prev F4=Next
An asterisk (*) indicates the intention to do more than one Move for this Item #, for more than one Pallet.
Values entered for Item #, Location, PO, Supplier, and any other Tracked By fields will remain locked
while looping on Pallet, after entering them for the first Move:
123
Qty:
Pallet: *
Total Qty:
30.00000
F4=Done
349