Wasp Barcode Inventory Control - Manual (Page 308)

InventoryControl Printable Help
4. Normally, you should not have to make changes to the values set by the Auto Detect function, but
changes can be made to the COM Port Settings, if necessary:
Specify the Serial Port to which your PDT is connected. The Serial Port drop list will display
COM1 through COMn where 'n' is the highest address found on your system.
Specify the Baud Rate at which your PC is to communicate with the PDT. It is recommended that
you use the default value of 19200, reducing the Baud Rate to lesser values only if you encounter
difficulty transferring files.
Specify the Parity and Stop Bits for the serial port if it is not defined with the defaults shown
above (None and 1, respectively.)
If InventoryControl is not already installed, you will receive the following message:
5. Click Yes to install the program.
While it is loading you will see a status bar and the device will beep occasionally.
293