Wasp Barcode Inventory Control - Manual (Page 334)

InventoryControl Printable Help
1. Scan or key in a Location value. The Location field is required for all Add transactions.
Enter a Location and press F4 to advance to the next data entry field.
Press F1 to go back to the previous data entry field.
Press ESC to cancel transaction and return to the previous screen.
Add
123
Monitor
Location:
Warehouse1
ESC=Cancel
F1=Prev F4=Next
2. If you press F4 to advance to the Supplier field, without first providing a Location value, the
following message will be displayed:
Please scan or key
in location
ESC=Exit
Press ESC to Exit the error message and then provide the required Location value.
If you are prompted to confirm a new Location that you believe should already exist in the
database, press the ESC key to cancel, then return to the Main Menu to check Site Config. If the
Location you entered exists only at a Site other than the currently selected Source Site,
InventoryControl must treat that value as a new Location for the Source Site. Select a different
Source Site in Site Config if that's where you intended to perform this transaction.
When a Location value has been entered, press F4 to advance to the next required field.
Add
123
Monitor
Supplier:
ESC=Cancel
F1=Prev F4=Next
3. PO and Supplier values might be required for this Item # if track bys were set when the item was
created. If not, the fields can be left empty or values may be entered optionally. For more
information on Track by fields, please refer to the topic
Creating New Items .
Press F4 to advance to the next data entry field.
Supplier:
ACME
New entry. Press ENT
to accept or ESC to
cancel.
Ent=OK
319