Wasp Barcode Inventory Control - Manual (Page 331)

InventoryControl Printable Help
Configuring Sites:
1. The Site Config function can be accessed by selecting the 6 key on the PDT Main Menu, or the
3 key if the PDT is in Audit Mode.
Site Config
Source/Dest Site
*(Select)
*(Select)
F1=Src F2=Dest
ESC=Menu
2. Select a Source Site by pressing the F1 key.
Source Site:
Warehouse 1
Press Ent to accept.
ESC to cancel
F1=Prev F4=Next
Above, the site WAREHOUSE 1 can be accepted as the Source Site by pressing the key
to accept the value.
or
Press the F4 key to scroll to the next Site in the PDT database.
or
Press the F1 key to scroll to the next Site in the PDT database.
or
Press the Escape key to cancel.
When a Source Site is selected, a screen similar to the one below will appear:
Site Config
Source/Dest Site
*Warehouse 2
*(Select)
F1=Src F2=Dest
ESC=Menu
3. Select a Destination Site by pressing the F2 key.
Dest Site:
316