Wasp Barcode Inventory Control - Manual (Page 363)

InventoryControl Printable Help
An asterisk (*) indicates the intention to do more than one Move for this Item #, to more than one
Location. Values entered for Item #, PO and Supplier, if any, will remain locked while looping on
Location after entering them for the first Add. Tracking fields are needed only for any Tracked By options
enabled for the Item entered.
In the example below F3 was pressed when prompted for Location and then values for Location, PO,
Supplier, any Tracked By's, and a Qty of 10 were entered, this screen is ready to receive inputs for
another Add. PO, Supplier and Tracked By values, if any, for this second Add will be the same as those
supplied at the beginning of the loop, if any.
123
Qty:
Location:
Total Qty:
10.00000
F4=Done
While looping on Location, all that is required for each Move are values for Qty and Location. The Total
Qty field is incremented each time a Move is submitted while looping.
Press the ENT key to submit the Move transaction and continue looping or press the F4 key to exit the
loop.
Looping on Item Number:
Fields can be looped, or pinned, by pressing the F3 key.
In the following example, F3 was pressed when prompted for Item #:
Move
Item #:
*
Scan or key in value
and press Ent.
Press ESC for Menu
Above, the asterisk (*) indicates the intention to loop on Item #. Values entered for Location, PO,
Supplier and any Tracked By fields (other than Serial Number) will remain locked after entering them for
the first Move:
Qty:
Item #:
Count:25
F4=Done
348