Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 119)

Load Initial Profile Setpoints
Chapter 8
8-2
The following two pages contain Worksheet 8-A for the clamp close
profile (one page for bit entries and one for word entries). The valve
spanning procedures in chapter 9 require specific values. We have already
recorded many setpoints for you on the worksheet. You must determine the
remaining setpoints based on your specific machine.
Important: You record setpoints for pressure vs. position and velocity vs.
position profiles on Worksheet 8-A. We assist you in determining values.
Determine and Record
Setpoints for the
Clamp Close Profile (CPC)