Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 12)

Preface
P-5
The following table lists documentation necessary for the successful
application of the QDC Module:
Publication Use this documentation: To:
1785Ć6.6.1 PLCĆ5 Family Programmable
Controller Installation Manual
Install the PLCĆ5 processor and I/O modules.
6200ĆN8.001 6200 PLCĆ5 Programming
Software Documentation Set
Select instructions and organize memory when
writing ladder logic to run your machine.
1771Ć4.10 Plastic Molding Module
Application Guide
Help select the module mode and match your
QDC module to your hydraulic layout.
1771Ć6.5.85
1771Ć6.5.86
1771Ć6.5.87
Plastic Molding Module User
Manuals for other modes.
Configure, program, install, and operate your
QDC module to control molding operations.
1771Ć6.5.88 Plastic Molding Module
Reference Manual
Program block transfers between PLCĆ5
processor and QDC module. Also, information on
PLCĆ5 data transfer logic.
Take time now to familiarize yourself with the Reference Manual
(publication 1771-6.5.88). The four sections include:
a summary of each data block used by the QDC module
(abbreviated command and status blocks)
programming error codes returned by the QDC module for each data
block, and recommended procedures to correct these errors
detailed listing and explanation of each command word and bit used by,
and each status word and bit returned from, the QDC module
operational, electrical, and environmental specifications of your module
If you purchased the Pro-Set 600 software, you also need the following:
Publication Use this documentation: To:
6500Ć6.5.11 ProĆSet 600 Software
Designers Guide
Select the ProĆSet 600 software that matches
the requirements of your molding machine.
6500Ć6.5.12 ProĆSet 600 Software
Assembly Manual
Transfer your ProĆSet 600 software from a
floppy disk to your hard drive. Add Overlays into
your PLCĆ5 and PanelView application files.
6500Ć6.5.13 ProĆSet 600 Software
Overlay Installation Manual
Install ProĆSet 600 overlays into your application
files.
6500Ć6.5.14 ProĆSet 600 Software
Customization Manual
Customize your ProĆSet 600 build for your
machine control requirements.
6500Ć6.5.15 ProĆSet 600 Software
Reference Manual
Support customizing your software control
system.
Related Publications