Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 127)

Load Initial Profile Setpoints
Chapter 8
8-10
The following two pages contain Worksheet 8-B for the injection profile
(one page for bit entries and one for word entries). The valve spanning
procedures in chapter 9 require specific values. We have already recorded
many values for you on the worksheet. You must determine the remaining
setpoints based on your specific machine.
Important: You record setpoints for a pressure vs. time and a velocity vs.
position profile on Worksheet 8-B. We assist you in determining them.
Determine and Record
Setpoints for the
Injection Profile (IPC)