Inc profile - velocity valve, 9ć25, Span your valves chapter 9 – Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE User Manual
Page 191: Confirm critical values
Span Your Valves
Chapter 9
9-25
Span your flow valve for optimum velocity performance in three parts:
Confirm critical values
Span your injection flow valve
Test valve linearity with a velocity vs. position profile
Important: You may omit the procedure Span your injection flow valve in
this section if the recorded valve spanning data from the manufacturer in
velocity control limits INC45-48 (chapter 7) are adequate for your
application.
Confirm Critical Values
Confirm that all entries you made for configuration values (chapter 7) and
profile values (chapter 8) are correct for the velocity vs. position profile.
Important: Use the following configuration and profile values:
On Worksheet Confirm Your Configuration
With These Words or Bits
ProĆSet Addr.
7ĆE, 7ĆG
QDC module output to which you connected
your flow control valve
INC02ĆB02, B01, B00
your selection
B38/16, 17, 18
SetĆoutput values for outputs to unselected
valves
INC09Ć12 = your values
N44:5, 6, 7, 8
All ramping is disabled with zero ramp rates
INC17Ć20 = 0
INC25Ć28 = 0
N44:13Ć16
N44:21Ć24
Velocity limits:
Minimum Velocity Control Limit
Maximum Velocity Control Limit
Selected Velocity Valve, Output for Min
Selected Velocity Valve, Output for Max
INC45 = 0
INC46 = max velocity per valve specs
INC47 = your value
INC48 = your value
N44:41
N44:42
N44:43
N44:44
EndĆofĆprofile setĆoutput values
HDC33Ć36 for zero output
N44:209Ć212
8ĆB, 8ĆC
Velocity units are inches (mm)/sec
IPC03ĆB14 = 1
B38/110
OpenĆloop control
IPC04ĆB03 = B02 = B01 = B00 = 1
B38/112Ć115
Expert Response Compensation (ERC) = Off
IPC04ĆB11 = B10 = B09 = B08 = 1
B38/120Ć123
Velocity setpoints
IPC09,13,17,21,25,29,33,37,41,45,49
all equal to max velocity per valve specs
start @ N44:65
end @
N44:105
EndĆof segment position setpoints
IPC11, 15, 19, 23, 27, 31, 35, 39, 43, 47,
equal segments over length of travel
start @ N44:67
end @
N44:103
Logical bridge to stop and set outputs
HPC03ĆB08 = 1
B38/296
INC Profile -
Velocity Valve