Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 304)

Index I–5
clamp open velocity, 9Ć48
ejector pressure, 9Ć53
ejector velocity, 9Ć58
injection pressure, 9Ć20
injection velocity, 9Ć25
pack and hold pressure, 9Ć31
plastication backpressure, 9Ć37
ValveĆspanning procedures, for, clamp low
pressure close, 9Ć4
velocity setpoints
clamp, 10Ć24
CPC, 8Ć7
EPC, 8Ć45
injection, 10Ć10
IPC, 8Ć14
OPC, 8Ć36
velocity units, selection of, 8Ć5 , 8Ć13 ,
8Ć34 , 8Ć42
W
watchdog timer, 10Ć19
for profiles, 7Ć30 , 10Ć34
wiring, QDC module I/O, 2Ć7
word numbering, PĆ4
worksheets
configuration worksheet list, 7Ć2
configure EAC, ERC, 7Ć17
configure FCC, SCC, TCC, 7Ć3 , AĆ8
configure FOC, SOC, TOC, OSC, 7Ć15 ,
AĆ20
configure HDC, 7Ć11 , AĆ16
configure INC, 7Ć7 , AĆ12
configure LPC, 7Ć5 , AĆ10
configure PKC, 7Ć9 , AĆ14
configure PLC, 7Ć13 , AĆ18
jog ram, clamp, ejector, 5Ć3
jog screw-rotate, indirect, 5Ć8
pressure alarm setpts, 3Ć16
profile worksheet list, 8Ć1
profile, CPC values, 8Ć3
profile, EPC values, 8Ć40
profile, HPC values, 8Ć19
profile, IPC values, 8Ć11
profile, OPC values, 8Ć32
profile, PPC values, 8Ć25
QDC module parameters, 3Ć2
sensor config values, 3Ć5 , 3Ć9
sensor I/O ranges, 3Ć3
software travel limits, 3Ć15
Worksheets, for, I/O ranges, 2Ć1
Z
zone overrun, 10Ć28
selection of, 8Ć34