Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 135)

Load Initial Profile Setpoints
Chapter 8
8-18
After you determine initial values and record them on Worksheet 8-B, you
are ready to proceed. Refer to procedures in chapter 4 if necessary.
Important: Be sure that you do not alter any setpoints, and that you enter
each and every setpoint exactly as on the worksheet.
1. Enter all worksheet values into your PLC-5 data table.
2. Download command blocks to the QDC module. We repeat the IPC
block download data.
Block to
Download
ProĆSet 600
Block ID
Download
Command Bit
Companion
Block
IPC 09 B21/8 none
3. Check SYS61 and SYS62 for programming errors. Correct as needed.
The following two pages contain Worksheet 8-C for the pack/hold profile
(one page for bit entries and one for word entries). The valve spanning
procedures in chapter 9 require specific values. We have already recorded
many values for you on the worksheet. You must determine the remaining
setpoints based on your specific machine.
Important: You record setpoints for a pressure vs. time profile on
Worksheet 8-C. We assist you in determining these values.
Enter and Download your
Worksheet Values
Determine and Record
Setpoints for the
Pack/Hold Profile (HPC)