Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 156)

Load Initial Profile Setpoints
Chapter 8
8-39
The following two pages contain Worksheet 8-F for the ejector profile (one
worksheet for bit entries and one for word entries). The valve spanning
procedure in chapter 9 requires specific values. We have already entered
those values for you on the worksheet. You must determine the remaining
setpoints based on your specific machine.
Important: You enter setpoints for a pressure vs. position profile on
Worksheet 8-F. We assist you in determining them.
Determine and Record
Setpoints for the
Ejector Profile (EPC)