Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 150
Creating a Sample Application File
Chapter 5
5-36
The addresses for this push button are on the Object Address List
shown in Chapter 4 (see
Figure 4.14
). To define the Button Control
Address:
a.
Choose Communication and then Discrete.
b.
Choose Rack and then 1. You’ll notice that “1” was your only
choice in the option list. This is because you only defined the
one rack when you defined Rack Assignments at the beginning
of this tutorial.
c.
Choose Start Word and type 0.
d.
Choose Start Bit and type 1.
e.
Choose Update Address. You’ll see the current address
displayed on the top line of the Button Control Address window.
f.
Choose Quit or press Esc to close the Button Control Address
menu.
7.
Choose Indicator State Address. These addresses are in the Object
Address List shown in Chapter 4 (see
Figure 4.14
). To define the
address:
a.
Choose Communication and then Discrete.
b.
Choose Input/Output and choose Output.
c.
Choose Rack and then 1.
d.
Choose Start Word and type 0.
e.
Choose Start Bit and type 1.
f.
Choose Update Address. You’ll see the current address
displayed on the top line of the Button Control Address window.
g.
Choose Quit or press Esc to return to the Object menu.
8.
Open the Utility menu, and choose Name.