Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 252)

Information and Alarm Windows
Chapter 7
7-44
The first alarm shown will be the first in the current or subsequent pages
with a quantity or accumulated time of greater than 0. The first alarm in the
Past Alarms screen acts as an anchor to the screen of alarm messages.
When a new alarm (an alarm with has not been active since the last reset)
is entered on the screen, the alarms below the new entry shift downwards.
If a past alarm becomes active which is before the first alarm on the screen,
or after the last alarm on the screen, the list of alarms will not change.
Instead a message “Additional Alarms: Use Page-Up to View” or
“Additional Alarms: Use Page-Down to View” appears to show that there
is information above or below the alarms which are displayed.
Figure 7.36
Alarm Status Screen (Past Alarms Mode)
92
22607
Change
Mode
Page
Down
Page
Up
Msg Accum Time Alarm 06/22/93 03:44:52 PM
# Qty HH:MM:SS State Message Mode: Display Past Alarms
1 5 00:02:18 ON This is alarm message 1
4 2 00:00:00 OFF This is alarm message 4
Reset
Qty/Time
Print
Status
Line
Down
Additional alarms: Use PageĆUp or PageĆDown to view
Last QTY/TIME Reset occurred at: 06/21/93 14:07:35
v